Anti-Shock Protection
This function minimizes sound interruption caused by vibrations, by utilizing audio data that has been stored in the memory ahead of the following time: For Audio CD: Up to 45 seconds worth (Anti-Shock Protection on/off selectable) For MP3: Up to 120 seconds worth at 128 kbps (Anti-Shock Protection is fixed to on.)
Preventing Accidental Operation (Hold mode)
The HOLD switch on the unit/remote control is prepared to prevent an accidental operation by an unexpected button press.
Hold mode prevents the following:
� Powering on the unit accidentally (which can cause the batteries to go dead). � Play being cut off unexpectedly. � Unexpected operation during play. (Set the HOLD switch to the ON position after you start playing disc.)
Normally, �ASP� and the A.S.P. progress meters are displayed and the Anti-Shock Protection is in effect.
ON
HOLD OFF
To set the unit/remote control in Hold mode
� Set the HOLD switch on the unit/remote control to the ON position. The all buttons on the unit/remote control are disabled. A.S.P. indicator When the disc is played, as the audio data gradually stored in the memory, the A.S.P. progress meter progresses. [Fully stored]
�HOLD� indication
When the unit is in Hold mode, �HOLD� will be displayed if a button on the unit is pressed.
HOLD
To cancel (Audio CD only)
Press the A.S.P./T.SEARCH button in stop mode or during playback. �ASP OFF� appears on the display.
To release the Hold mode
Set the HOLD switch to OFF position.
Notes:
� Before turning on the unit, be sure that HOLD is OFF. Otherwise, you cannot turn on the unit. � The HOLD switch on the unit is effective for the unit only. While, that on the remote control is effective for the remote control only.
To activate again (Audio CD only)
Press the A.S.P./T.SEARCH button.
Notes:
� The Anti-Shock Protection can be enabled or disabled during play, and this may cause a slight interruption in the sound because the disc�s rotational speed changes. � Turning off the Anti-Shock Protection will save battery life more or less.
Using the Remote Control
Preparation:
Release the remote control from the Hold mode. � � � �
HOLD
Using with an audio system
You can use an audio system by connecting it to the unit with a stereo connection cable (not supplied). Connect the cable to the amplifier after turning off its power. Do not connect the cable to the PHONO jacks on the amplifier. Obtain the optional connecting cable if the amplifier comes with mini-phone jacks. Adjust the volume level on the amplifier. LINE OUT jack
Left side panel of the unit
How to use the remote control
Press during off or stop mode. Stereo connection cable (not supplied) Amplifier (White)
To start play
(Red) Press during play.
Note:
To obtain original sound, turn HBS to OFF. Also, set the sound effect to �FLAT�. (See page 7)
To stop play
Press during stop mode.
To turn off the unit
Skip function
Press during play. Forward
Fast forward/reverse
Reverse
Search function
Keep depressed during play. When adjusting the volume using the remote control, set the volume control on the unit to an appropriate position.