Press the or button to adjust the hour and then press the MEMORY/SET(MEMORY) button.
Press the or button once to advance the time by 1 hour. Hold it down to advance continuously.
/
6
Press the or button to adjust the minutes and then press the MEMORY/SET(MEMORY) button.
In this example, the clock is set for the 24-hour (0:00) display.
Press the or button once to advance the time by 1 minute. Hold it down to change the time in 5-minute intervals. To con�rm the time display: [When the unit is in the stand-by mode] Press the CLOCK/TIMER button. The time display will appear for about 10 seconds. [When the power is on] Press the CLOCK/TIMER button. Within 10 seconds, press the or button to display the time. The time display will appear for about 10 seconds. Note: The "CLOCK" will appear or time will �ash to con�rm the time display when the AC power supply is restored after a power failure or unplugging the unit. If incorrect, readjust the clock as follows. To readjust the clock: Perform "Setting the clock" from step 1. If the "CLOCK" does not appear in step 3, step 4 (for selecting the 24-hour or 12-hour display) will be skipped. To change the 24-hour or 12-hour display: 1 Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" on page 36 for details.] 2 Perform "Setting the clock" from step 1. Note: The clock can also be set with the remote control.
1 2 3
Press the ON/STAND-BY button to turn the power on. Press the CLOCK/TIMER button. Within 10 seconds, press the or button to select "CLOCK", and press the MEMORY/SET(MEMORY) button.
4
Press the or button to select 24-hour or 12hour display and then press the MEMORY/SET(MEMORY) button.
"0:00" "AM 12:00" "AM 0:00"
The 24-hour display will appear. (0:00 - 23:59) The 12-hour display will appear. (AM 12:00 - PM 11:59) The 12-hour display will appear. (AM 0:00 - PM 11:59)
