1. On the remote controller, press the [RGB] key to select RGB
input source.
You can also select the input source using the projector�s [INPUT] key.
as the
2. On the remote controller, press the [P-IN-P] key to display the subwindow.
This causes the sub-window, containing the image input through the VIDEO or S-VIDEO terminal, to appear on the projected image. The sub-window will be located at the position that was used the last time a sub-window was displayed. The initial default location is the lower right corner. You can leave the sub-window where it is, or move it to another location within the projected image. See �To change the location of the sub-window� for more information. You can also select one of three sizes for the sub-window. See �To change the size of the sub-window� for more information.
3. To close
the sub-window, press the remote controller�s [P-IN-P] key or the [ESC] key.
To change the location of the sub-window
While a sub-window is displayed, use the remote controller�s cursor keys to move it to one of the nine locations shown below.