PIONEER X-HX700
Manual de Usuario

Setting the Time
Example: To set the time to 7:15 AM

The time (24-hour format) is indicated on the CD/receiver�s display panel. The first time the power is connected, the display panel flashes to indicate that the time needs to be set. Use the CD/receiver�s buttons to do this as described below.
Display panel: shows the current time

1 Press and hold the TIMER SETTING
button for at least three seconds.
The CD/receiver turns on and the back light of the display panel lights.
Display panel

The �Hour� flashes.

2 Use the + and/or � buttons to set the
hour, then press the ENTER button.
Display panel
,,,,, ,,,,,,, ,,,,,, ,,, ,,, ,,,,, ,,,,,,, ,,,,,, ,,, ,,, ,,,,, ,,,,,,, ,,,,,, ,,, ,,, ,,,,, ,,,,,,, ,,,,,, ,,, ,,,

The �Minute� flashes.

3 Use the + and/or � buttons to set the
minute.
CANCEL button + / � button

ENTER button

One way to ensure an accurate time setting is to temporarily set a time that is slightly faster than the actual time, then use the time announcements on the radio or TV to set the time. After doing this, go on to Step 4 below.

TIMER SETTING button

4 Press the ENTER button.
Display panel

PREPARATIONS

Before setting the time
Turn the system�s power off before making the time settings. If the power is currently on, press the POWER button to switch it off.
The CD/receiver turns off, then the clock starts to run.

How to cancel
Press the CANCEL button while setting the time (before pressing ENTER at Step 4). This resets the time to its status prior to Step 1.

Note on the time display
The time display does not appear when the system�s power is on.

You must reset the time setting in the following situations:
� The power plug has been disconnected from the wall outlet, such as when moving the system. � A power outage has occurred.

17