First Use
Batteries - Remote Control
To insert or replace the batteries press where the arrow is imprinted. Slide the battery compartment cover downwards and remove it. Insert batteries of the type Alkaline Manganese LR 03 (AAA) and make sure + and � poles are the right way round.
Connection
Power supply Connect the TV set to a 230V/50-60 Hertz socket. Aerials Connect your aerial or cable system to the VHF/ UHF aerial socket. If the set is equipped with a Picture in Picture tuner (PIP), plug the aerial plug which emerges above the antenna socket into the antenna socket for the PIP tuner. If the set is equipped with one or two satellite tuners, connect the Sat aerials to the SAT sockets (see fig. page 45).
Switching on for the first time
The TV�s automatic programming is activated the first time you switch it on. First you have to select the menu language for your TV set. Then specify which aerial you have connected to your TV and in which country you are operating it. Follow the menus and then start the automatic programming. Select the settings with the arrows on the ring ...
+
+
Then slide the cover back up. Notes on battery disposal: The original batteries do not contain any pollutants such as cadmium, lead and mercury. Used batteries do not belong in the domestic waste. They must be taken to the appropriate collection points according to the national laws. Ask your dealer.
Switching on
Press the On/Off key so that it clicks into position.
OK
... confirm your settings with OK. You then come to the next menu ... ... press this key if you need information about the settings.
i
Use the pre-programmed satellite stations if necessary, otherwise they will be erased. Once you have answered all the questions for the automatic programming, your settings will be displayed. Check whether all the settings are correct. Then start the automatic programming with the OK key. The TV searches for, saves and sorts all the channels that can be received by your aerial system. The channel preview will be displayed after the automatic programming. You can repeat switching on for the first time at any time, e.g. after moving house or retrofitting satellite tuners. Call up the index in the Main Information (i-key). Then select the index item �First time switching on - repeat�. Then start �First time switching on� with OK.
