|
Usuarios conectados
Actualmente hay 6000 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
RADIO OPERATION
Tuning
ON/STANDBY button to turn the power on. 2 Press the TUNER (BAND) button. 3 Press the TUNER (BAND) button to select the desired frequency band. (FM ST, FM or AM) 4 Press the TUNING/TIME (%UP or �DOWN) button to tune into the desired station.
1 Press the
1 2,3, 5,6
Manual tuning : 4
Press the TUNING/TIME (%UP or �DOWN) button as many times as required to adjust the frequency shown on the display to the frequency of the desired station.
Auto tuning :
When the TUNING/TIME (%UP or �DOWN) button is pressed for more than 0.5 second, scanning will start automatically and the tuner will stop at the first receivable broadcast station.
4 1
2,3, 5,6
Notes : � When radio interference occurs during auto scan
tuning, auto scan tuning may stop automatically at that point. � If a weak station signal is found during auto scan tuning, the station will be skipped. � To stop the auto tuning, press the TUNING/TIME (%UP or �DOWN) button again. � When a RDS (Radio Data System) station is tuned in, the frequency will be displayed first, and then the RDS indicator will light up. Finally, the station name will appear. 5 To receive an FM stereo transmission, press the TUNER (BAND) button so that the �ST. indica� tor on the display lights up. � � � will light up when an FM broadcast is in stereo. 6 If the FM reception is weak, press the TUNER (BAND) button so that the �ST. indicator goes � off. The reception changes to mono, the sound becomes clearer.
After use :
Press the ON/STANDBY button to enter the standby mode
Note : � The last station turned in will be recalled, even
after changing the tuning band or the function, or after switching the unit to the standby mode.
�
19 EN
|
|
|
> |
|