Installation
Connecting the Head Unit and the Control Unit (XC-55BB)
Installing the ferrit core
If you use this camera module in Europe, install the ferrit core on the cable. Install the ferrit core on the control unit side of the cable. Wrap the cable around the ferrit core (see the figure), then close it. Make sure that the cable is not caught between the pawls of the ferrit core.
1 1
Slit Small protrusion
Connect the cable (supplied) to control unit. Match the small protrusion with the slit in the plug. Insert the plug and tighten the screw. Similarly, connect the plug to head connector.
2
After connecting the cable, turn on the monitor power, then, turn on the power for the camera control unit.
Screw Control unit
Notes
2
� Do not touch the lens surface. Make sure the lens is clean. � You can connect either cable end to the control unit or head unit.
Pawl
Small protrusion
Slit
About 150 mm
Head unit Screw
48
49
1-5 (E) XC-55/55BB
Installation Mounting a Lens Installing the C-mount lens to the XC-55
Install the NF-mount lens (special lens) onto the XC-55BB
1 2
Turn the lens mount cap and remove it. Install the lens by rotating it.
1 2
Turn the lens mount cap and remove it. Mount the lens (not supplied) by screwing it on.
1
Applicable lenses The lens must not project more than 7 mm (9/32 in.) from the lens mounted surface.
Lens mounted surface 7 mm (9/32 in.) or less
1
The following lenses can be used: Special NF-mount lens (not supplied) � VCL-12S12XM (f=12mm) � VCL-06S12XM (f=6mm) � VCL-03S12XM (f=3.5mm) � VCL-12SXM (f=12mm)
