Installation
Connecting the water purifier
Before the water purifier is placed in its intended position, remove the plug at the end of the reject water hose and the two plugs in the connections on the purifier, see fig. H. Connect the two hoses and the faucet cord to the appliance as shown in fig. I.
H
Feed water
1. Screw the bent end of the feed water hose onto the water purifier. Check that the seal is in place in the connection. See fig. I no. 1. Open the shut-off valve on the feed water and check that there is no leakage at the feed water hose.
2.
Pure water
The pure water is routed via the pure water hose to the faucet installed on the sink unit. 1. Connect the pure water hose from the pure water faucet to the water purifier. Push the hose into the bottom position, up to the mark (approx. 19 mm). See fig. I no. 2.
I
Reject water
The reject water hose has already been connected to the water purifier on delivery. The other end of the hose is connected to the waste water pipe.
2
Indicator light
1. Connect the cable to the faucet indicator light, as shown in fig. I no. 3, and place the water purifier in the intended position.
1
3 Electrical connection
1. Connect the plug to the earthed wall socket as shown in fig. J.
The water purifier starts and flushes for 90 seconds. Flushing is performed every time the plug is connected. Do not drink the water until the flushing procedure under «Flushing» has been completed.
