INSTALLATION INSTRUCTIONS
WATER SUPPLY
� � � Water supply: cold water only Tap: 3/4� threaded hose connection Pressure: 100-1000 kPa (1-10 bar).
WATER INLET HOSE
1. The mesh filter supplied with the appliance must be inserted in the connection between the inlet hose and the tap. 2. Carefully screw the hose connection onto the tap preferably by hand. Make sure there are no kinks in the hose. 3. Check water-tightness of tap and appliance connections by turning the tap completely on. � If the hose is too short, replace it with a suitable length of pressure resistant hose (1000 kPa min, EN 50065 approved type). � Periodically check the hose for brittleness and cracks and replace if necessary. � The appliance can be connected without an antibackpressure valve. � Install the appliance in accordance with regulations of your local water company.
Straight hose
Water Stop hose
WATER STOP (depends on model)
Screw the threaded connector with the filter inserted onto the tap. Open the water tap fully and check the water-tightness of the connection point. � The appliance must not be connected to the mixing tap of a non-pressurized water heater. � The inlet hose and the plastic enclosure at the tap connection contain electrical components. N.B. Do not cut the hose and do not immerse the plastic enclosure in water. � If the flexible hose is damaged, unplug the appliance from the mains immediately. � If the hose is too short, replace it with a 3 m Water Stop hose (available from After-Sales Service or from your dealer). This operation must be carried out exclusively by a licensed electrician. �
DRAINING
� Connecting the water drain hose. Connect the drain hose to the siphon or hook it over the edge of a sink by means of the �U� bend (see figure). The drain hose should not be hooked onto small washbasins. Max. drain height: 1.25 m If you need to add an extension, use a flexible hose of the same type and secure the union with screw-on hose clips. Max. drain hose length: 2.50 m Important: Make sure there are no kinks in the hose. Secure the hose so that it cannot fall down while the appliance is running.