TOSHIBA W704
Manual de Servicio

PLAYBACK

Playback
This section explains the basic playback operation. Preparation � Select the video channel (3 or 4) or video input mode on the TV. � Press VCR to set the remote control operating the VCR.

VCR
1 4 7 2 5 8 0 3 6 9
100

Basic Playback

CH/TRK

1

Load a recorded cassette.
POWER

Power is turned on. If the cassette has no safety tab, playback starts automatically.

PLAY/x2

2
FF

2 3

Press PLAY/x2 to start playback.

POWER S P VCR
DT

REW

FF

STOP

3 19µ
REW

To stop playback, press STOP.

Rewinding / Fast-forwarding Press REW or FF in the stop mode.

Adjusting the tracking
When playback starts, the VCR automatically adjusts the tracking for clear pictures and sound (Digital Auto Tracking). The �DT� indicator blinks during the adjusting. If the VCR cannot locate the best possible tracking point, hold down one of CH/TRK to adjust the tracking manually. � To resume the digital auto tracking, hold down both CHANNEL on the VCR simultaneously for about 2 seconds.
Notes � During the adjusting, the playback picture and sound may be distorted. � The digital auto tracking is activated only in the playback mode. � To reset the manual tracking point to the center, press both CHANNEL on the VCR simultaneously for not longer than 1 second. � The noise on the screen may not be completely eliminated depending on the tape used, especially when the tape was recorded on another VCR.

19µ HEAD
You can view high quality pictures while playing back a tape recorded in the SLP tape speed. By pressing 19µ repeatedly, the 19µ HEAD mode is displayed on the TV screen as follows: 19U-HEAD AUTO: Usually set to �AUTO�. As the playback starts, the VCR automatically activates the 19µ head and reproduces high quality pictures. 19U-HEAD OFF: Set to �OFF� if the pictures are marred by dots.
Note During playback with the 19µ head, momentary noises or shakes may be produced when you change the mode to the picture search or variable speed playback.

20