5. Alignment and Adjustment
5-1 Reference
1) X-Point (Tracking center) adjustment, �Head switching adjustment� and �NVRAM option setting� can be adjusted with remote control. 2) When replacing the micom (IC601) be sure to adjust the �Head switching adjustment� and �NVRAM option setting�. 3) When replacing the cylinder ass�y, be sure to adjust the �X-Point� and �Head switching adjustment�. 4) Remote control used for same chassis as a accessory is available for all adjustments. 5) How to adjustment. - Intermittently short-circuit the test point on Main PCB with pincets to set the adjustment mode. - If the corresponding adjustment button is pressed, the adjustment is preformed automatically. - If the adjustment is completed, be sure to turn the power off.
5-1-1 Location of adjustment button of remote control
