Manual Clock Set
If AUTO CLOCK SET was incomplete, manually set the clock as follows.
Reset all unit Memory Functions
Initial Setup
When moving unit to a new location, or if a mistake was made in the Initial Setup section.
� Make sure a tape is not inserted in the unit.
1
Press ACTION on the remote to display SET CLOCK Menu screen.
SET CLOCK
1/ /
:
DST : ON
SELECT : END : ACT I ON
SET :
2
Press to select the month and press to set. In the same manner, select and set the date, year, time, and DST. (Daylight Saving Time)
VIDEO IN AUDIO IN
POWER
VOL
CH
STOP/EJECT REW/
ACTION
PLAY/REPEAT FF/
REC
TIMER
REC ON TIMER PROG TIMER
SET CLOCK
2 / 6 / 2003 THU 12: 00PM
DST : ON SET COMPLETED
1 2
Turn the unit Power on. Press and hold both PLAY/REPEAT and FF on the unit for more than 5 seconds.
� The power will shut off. � Please ignore �NO CASSETTE� warning.
SET : START : ACT I ON
3
Press ACTION twice to start CLOCK and exit.
3
POWER
Do �Initial Setup� on page 8.
ACTION
SELECT/SET :CH UP :CH DOWN :VOL UP :VOL DOWN
Note to CABLE System Installer This reminder is provided to call the CABLE (Cable TV) System Installers attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, speci�es that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.