PIONEER VSX-D811S/KUXJI
Manual de Usuario

06

Setting up the receiver

Surround back speaker distance setting
(VSX-D811S only) � Default setting: 10 ft. Like the center speaker, you should set the distance of the surround speakers accurately to hear sounds coming from both front and surround speakers at the same time. � Use � or � to set the distance of the

Dual mono setting
� Default setting: ch1 The dual mono setting can only be used when listening to Dolby Digital discs with dual mono encoding. These discs are not widely used, but are sometimes used when it is necessary to have one language on one channel and a different language on the other. With this setting you can choose which channel in the dual mono setting you want to listen to. If Dolby Digital mode is switched on, you will hear the channel you have selected (either ch1 or ch2) through your center speaker. With Dolby Digital mode off, or if you don�t have a center speaker, you will hear the channel you have selected through both front speakers. In the L ch 1. R ch 2 setting, the left front speaker will play channel 1 and the right front speaker will play channel 2. � Use � or � to cycle through the possible dual mono settings.

surround speakers from the main listening position (within a 30 foot range).

When SB is selected in the surround speaker setting, the surround back speaker distance can�t be set.

Dynamic range control setting
� Default setting: OFF Dynamic range is the difference between the loudest and softest sounds in any given signal. With this setting, you can compress the dynamic range, so that low level sounds can be heard more easily (sounding relatively louder) yet louder sounds won�t be too overbearing. � Press � or � to set the dynamic range control (OFF, MAX, or MID).

L ch 1.R ch 2

ch2

ch1

Component video input settings
Here you tell the receiver what components you have hooked up to the component video jacks on the back of the receiver.

� When the volume level is increased, set to OFF. � When listening at low volumes, set to MAX for maximum dynamic range compression. � Dynamic range control is effective only when a Dolby Digital signal is being played back.

Component video 1:
� Default settings: DVD 1 Use � or � to assign the component video 1 input (DVD, TV, VCR or OFF).

Component video 2:
� Default setting: TV 2 Use � or � to assign the component video 2 input (DVD, TV, VCR or OFF).

42
En