PIONEER VSXD3S
Manual de Usuario

REMOTE SET UP (GUI OPERATION)
NOTE: To return the buttons you used for learning to their original ÷ settings, press the CLEAR button. This returns them to the original Pioneer remote control commands. ÷ There are no signals in buttons � , �� , and ��� , so you can use them for learning. ÷ Even when �OK� is displayed during learning, operation may still not be possible. If this happens, repeat the learning procedures. With some manufacturers� components, learning may be difficult to perform. Learning may also not be possible if the remote control�s batteries are run down. If this is the case, load the remote control with new batteries and repeat the learning procedures. ÷ Even black preset buttons can be used for learning other commands. ÷ Learning a command may not be possible if many commands requiring a large amount of memory have already been learned resulting in insufficient memory remaining.

Learning
Pioneer remote control commands are in the non-preset gray buttons, but you can use them to learn remote control signals from your component�s remote control. 1. Perform the first three steps of �Calling up and setting up presets�. 2. Select the gray button you want to use for learning and press. The �STANDBY� indication flashes. (If you remain in STANDBY for about 1 minute, it is canceled.) (Example: Using the 0 button for learning)

REMOTE SET UP VCR 1 STANDBY
POWER

CLEAR TV/ VCR FUNC MTS

0�1�2�3�4 5�6�7�8�9
NEXT

CH� CH�

RCA SHARP ZENITH SONY

TOSHIBA HITACHI JVC PANASONIC
EXIT

3. Point your component�s remote control at this unit�s remote sensor window and press the selected button.

VSX-D3S

Press, holding the remote control unit within 50 cm (20 inches) of this unit�s sensor window.

�

�

�

�

�

�

÷ If �OK� is displayed, learning has been completed. If you want to use another button for learning, repeat steps 2 and 3.

REMOTE SET UP VCR 1 OK
POWER

CLEAR TV/ VCR FUNC MTS

0�1�2�3�4 5�6�7�8�9
NEXT

CH� CH�

RCA SHARP ZENITH SONY

TOSHIBA HITACHI JVC PANASONIC
EXIT

÷ If �NG� is displayed, repeat steps 2 and 3. ÷ When you have completed learning, press the EXIT button.

32
<ARB7050>