PIONEER VSX-AX10I-G/SDLPW
Manual de Usuario

Setting Up for Surround Sound

3

2.4. Acoustic Cal EQ Manual

3 To manually adjust CUSTOM1 or
CUSTOM2 use the 5� buttons to highlight one and press ENTER.

Please Wait Caution!! Test tone is output loudly. [Cancel]
63 250 500

4

2.4. Acoustic Cal EQ Manual Target Curve: CUSTOM1 Channel [L �SMALL]

4 If you're using a MANUAL setting, use the 2 3 buttons to select the speaker and press ENTER.

[Return]

5

2.4. Acoustic Cal EQ Manual Target Curve: CUSTOM1 Channel [L �SMALL]

5 Use the 2 3 buttons to select the frequency and 5� buttons to add or subtract decibels from that frequency.
Changing the frequency balance of one channel too drastically will result in a poor overall level balance. You can adjust the speaker levels using the TRIM feature, which allows you to align the speaker level while listening to the test tone. To use the TRIM feature, use 3 to move to the far right side of the OSD then use � and 5 to raise or lower the level of that channel.

[Return]

7

2.4. Acoustic Cal EQ Manual Target Curve: CUSTOM1 Channel [L �SMALL]

[Return]

6 When you have the frequency balance you want for that speaker press ENTER to move to the next speaker and repeat step 4. 7 Select RETURN with the 5� buttons when done and press ENTER.

memo

The message OVER !! indicates there is a possibility the sound will distort due to an extreme frequency balance. If this message appears, adjust the frequency balance accordingly.

1k 2k 4k 8k 16k

125

You will return to the SURROUND SETUP menu. If you want to check each of the settings of Acoustic Calibration EQ, select CHECK, press ENTER and proceed to CHECK THE AUTO SETTINGS (see p.51). If you want to exit the setup process, select RETURN and press ENTER, then select EXIT and press ENTER.

49
En

SURROUND SETUP