PIONEER VSAE03
Manual de Servicio

VSA-E03

8. PANEL FACILITIES AND SPECIFICATIONS
8.1 PANEL FACILITIES
Front Section
12 3 45 6 7 8 9 0- =~! @

AUDIO/VIDEO MUL TI-CHANNEL AMPLIFIER

N�z¿x?�
MASTER V OLUME

ST ANDBY

ST ANDBY/ON

DSP MODE

�

CHANNEL LEVEL

+

CHANNEL SELECT

SIGNAL SELECT

MIDNIGHT

�

OFF

-

ON DO WN UP

SPEAKERS A PHONES B

B ASS

TREBLE

�

+

�

+

LOUDNESS

DIRECT S-VIDEO

VIDEO INPUT VIDEO L A UDIO R

VCR

D VD/LD

TV/SA T

VIDEO

CD

TUNER

MD/T APE

A UX

D VD 5.1CH

#

$

%

^

&

1 Main power switch (� OFF, _ ON) 2 STANDBY/ON button
Press to switch the amplifier on or put in standby.

-

(Dolby) Surround button
Press to select the (Dolby) Surround mode. This mode automatically switches between Dolby Digital and Dolby Pro Logic decoding according to the input signal.

3 STANDBY indicator
Lights when the amplifier is in standby mode. (Please note that this amplifier consumes a small amount of power (1 W) during the standby mode.)

= SIGNAL SELECT button
Use to select input signals for the digital components. First press VCR, DVD/LD, TV/SAT, CD or MD/TAPE (%, Function buttons) to select the component, then press SIGNAL SELECT repeatedly to select one of the following: ANALOG : Selects the analog (R and L) audio signals. DIGITAL : Selects the digital audio signals. This amplifier automatically detects and displays the format of the signal being input. AC-3 lights when Dolby Digital signals are input. (AC-3 decoding is switched automatically.) � SIGNAL SELECT is fixed in the �ANALOG� position for components not assigned to one of the three digital input jacks. � Because the audio from a karaoke microphone and LD recorded with analog audio only is not output from the digital output, set SIGNAL SELECT to �ANALOG�. � This amplifier can only play back Dolby Digital, PCM (32kHz, 44kHz, and 48kHz) signal formats. With digital signal formats other than these, set SIGNAL SELECT to �ANALOG�.

4 CHANNEL SELECT button
Use to select a speaker when ajusting speaker levels.

5 SPEAKERS (A/B) buttons
Use to switch the corresponding speaker system on or off. To listen to both speaker systems (A and B), press the buttons so that both A and B appear in the display. Only A speakers are available when using surround sound modes.

6 BASS (�/+) button
Press to adjust low frequencies in the range of ±6.

7 Display 8 TREBLE (�/+) button
Used to adjust high frequencies in the range of ±6.

9 LOUDNESS button
Switches the loudness on or off. Use to raise the level of the bass and treble so they can be more easily heard when listening at low volumes.

0 Remote sensor
Point the remote control toward the remote sensor to operate the amplifier.

56