Low This adjusts the gain (-12 dB to +12 dB) and the shelving frequency (40 Hz-1.5 kHz) of the low-band EQ. Mid This adjusts the gain (-12 dB to +12 dB) and the center frequency (200 Hz-8 kHz), and the Q (filter sharpness) (0.516) of the mid-band EQ. The Mid band is not available when �2 Band EQ� is selected. High This adjusts the gain (-12 dB to +12 dB) and the shelving frequency (500 Hz-18 kHz) of the high-band EQ. ENTER Button When the cursor is positioned inside the EQ section, the ENTER button will be blinking. Press [ENTER] to view a graphic display of the EQ settings.
[F2 (FX2)] Effect 2 Send
Channel settings for the EFFECT 2 Bus. Sets the Effect Send Switch, the Send Level (0-127) and panning. Sw (Effect Send Switch) Switches the channel to the EFFECT bus. Off: The channel is not sent to the EFFECT bus. Pre: The signal is sent to the EFFECT bus before it passes through the mixer fader. Post: The signal is sent to the EFFECT bus after it passes through the mixer fader. Level Sets the channel�s send level (0-127) to the EFFECT 2 Bus. Panning Sets the channel�s panning (L63-R63) in the EFFECT 2 Bus.
[F5 (V.Trk)] V-Track Select
Selects the V-Track (1-16) for playback or recording. The V-Track setting is only available in the Track Mixer. The VS-1824 must be stopped before this value can be changed. A small box indicates that a recording has been made on the V-Track. A flat line indicates the V-Track has not yet been recorded.
[F3 (FX3)] Effect 3 Send
Channel settings for the EFFECT 3 Bus. Sets the Effect Send Switch, the Send Level (0-127) and panning. Sw (Effect Send Switch) Switches the channel to the EFFECT bus. Off: The channel is not sent to the EFFECT bus. Pre: The signal is sent to the EFFECT bus before it passes through the mixer fader. Post: The signal is sent to the EFFECT bus after it passes through the mixer fader. Level Sets the channel�s send level (0-127) to the EFFECT 3 Bus. Panning Sets the panning (L63-R63) of the channel to the EFFECT 3 Bus.
Chapter 6
[F6 (PRM.V)] Parameter View/ [F6 (CH.V)] Channel View
Changes the display from Channel View to Parameter View. Press [F6 (PRM.V)] to view the Parameter settings (such as Pan or Effect Send) for all channels. Press [F6 (CH.V)] to view the entire mixer settings for just one channel.
[F1(FX1)] Effect 1 Send
Channel settings for the EFFECT 1 Bus. Sets the Effect Send Switch, the Send Level (0-127) and panning. Sw (Effect Send Switch) Switches the channel to the EFFECT bus. Off: The channel is not sent to the EFFECT bus. Pre: The signal is sent to the EFFECT bus before it passes through the mixer fader. Post: The signal is sent to the EFFECT bus after it passes through the mixer fader. Level Sets the channel�s send level (0-127)to the EFFECT 1 Bus. Panning Sets the channel�s panning (L63-R63) in the EFFECT 1 Bus.
