PANASONIC VML450
Manual de Servicio

PV-D300 / VM-D100 / PV-L550 / PV-L600 / PV-L650 / VM-L450

5.1.7.
CAUTION:

HOW TO REMOVE A JAMMED TAPE

If loading does not start after DC Power Supply is applied, DO NOT continue applying DC Power Supply.

5.1.7.1.

Remove a jammed tape as follows:

1. Remove a Screw and remove the EVR Cover.

Fig. 4-2

5. Open the Cassette Cover fully.
Fig. 4-1

6. Remove the tape slack by rotating the Takeup Reel Gear of the cassette tape as shown in Fig. 4-3.

2. Place the unit with the Cassette Cover facing upward. 3. Connect the TP Board Kit through the TP Board slot. 4. Apply +3VDC Power Supply to TP20 (+) and TP21 (-) on the TP Board to unload the mechanism. It normally takes approx. 6 seconds to unload the Mechanism to EJECT position. Then, remove the Power Supply and remove the TP Board Kit.

Fig. 4-3

7. Take out the cassette tape. 8. Connect the Power or Battery to set the Mechanism to STOP Position.

20