NIKON VAA47001
Manual de Servicio

� �Revision)

Note: When the �rmware is updated without replacing the CP-1 PCB, follow the procedure shown below. Work procedure

VAA47001-R.3674.A

� Turn camera off and connect the AC adapter. � Insert the updating SD card into the camera. � Set the mode dial to �SETUP� and turn power on. � Select and decide �Firmware version� to access the �rmware updating menu. (Fig. 1)

(Fig.1) � Select �Yes� and press the [OK] button to execute upgrading the �rmware. (Fig. 2)
Note: Do NOT turn power off during writing.

(Fig.2) � When the display showing that updating of �rmware is completed appears on the screen, turn off the power and take the SD card
out of the camera. (Fig. 3)

(Fig.3) � Turn on the power and check the version on �Firmware version� of the menu. (Fig. 4) � Turn off the power. Updating is completed.

����

�Fig.4�

��課

ï¼­
Oct.5.2005 Revision page��� 1 - A38 ･ P2 -