3.1.4 Removing the rear cover (See Figs.11 and 12) � Prior to performing the following procedures, remove the side panels L/R and top cover. (1) From the left side of the main body, cut off the tie band attaching the barrier. (See Fig.11) (2) Disconnect the wire from the connector CN760 on the main board. (See Fig.11) (3) From the back side of the main body, remove the twelve screws J and screw K attaching the rear cover. (See Fig.12) (4) Remove the rear cover from the main body.
Wire
CN760
Tie band
Main board
Rear cover
Barrier Fig.11
J
J
Rear cover
K
3.1.5 Removing the fan (See Fig.13) � Prior to performing the following procedures, remove the side panels L/R, top cover and rear panel. (1) From the inside of the rear cover, remove the two screws L attaching the fan to the rear cover. (2) Take out the fan from the rear cover. Reference: After attaching the fan, pass the wire through the slots e and fix the wire with the spacer.