2
AM loop antenna (supplied) Right speaker Left speaker
1 Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
� If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.
1 Press and hold the clamp of the speaker
terminal on the rear of the unit.
2 Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)
2 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to red (+) and black (�) to black (�).
3 Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.
For better reception of both FM and AM � Make sure the antenna conductors do not touch any other terminals and connecting cords. � Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.
