Removing the main board / heat sink (See Fig.13 to 15)
Prior to performing the following procedure, remove the metal cover, the rear cover, the CD mechanism assembly and the rear panel. 1. Disconnect the card wire from connector CN900, CN901 and CN931 on the main board. Disconnect the wire from CN906 and FW903 respectively. 2. Disconnect the wire from W950 on the underside of the main board.
CN931 CN901 CN900 Main board
CN906
FW906
Fig.13 3. Remove the two screws I attaching the main board to the chassis on the left side ofthe body and disengage the two joints c. 4. Remove the two screws J attaching the heat sink to the main board.
