JVC UX-L46V
Manual de Usuario

Continued

Turning On the Power
When you press the play button�CD 3/8, TAPE 2 3, FM/AM and AUX/MD, the unit automatically turns on and starts playback if the source is ready. To turn on the unit, press STANDBY/ON . The STANDBY/ON lamp lights green and �HELLO� appears on the display.
STANDBY/ON

Adjusting the Volume
You can adjust the volume level only while the unit is turned on. The volume level can be adjusted between �VOL MIN� and �VOLUME 1� � �VOLUME 40 (VOL MAX).� When using the remote control, press VOLUME + to increase the volume or press VOLUME � to decrease it. When using the unit, turn VOLUME + / � clockwise (+) to increase the volume or counterclockwise (�) to decrease it.
VOLUME

STANDBY / ON

To turn off the unit (on standby), STANDBY/ON STANDBY / ON press STANDBY/ON again. The STANDBY/ON lamp lights red and �GOOD BYE� appears on the display. � �0:00� flashes on the display until you set the built-in clock. After setting the clock, the clock time will appear on the display while the unit is on standby. � A little power is always consumed even while the unit is on standby. To switch off the power supply completely, unplug the AC power cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs The clock is reset to �0:00� right away, while the tuner preset stations (see page 12) will be erased in a few days.

VOLUME

�

+

For private listening Connect the headphones to the PHONES jack. No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on headphones. DO NOT turn off (on standby) the unit with the volume set to an extremely high level; otherwise, a sudden blast of sound can damage your hearing, speakers and/or headphones when you turn on the unit or start playing any source next time. REMEMBER you cannot adjust the volume level while the unit is on standby.

Selecting the Sources and Starting Play
To play back CDs, press CD 3/8. (See pages 15 � 18.) To play back tapes, press TAPE 2 3. (See page 23.) To listen to FM/AM broadcasts, press FM/AM. (See pages 12 � 13.) To select the external equipment as the source, press AUX/MD.
CD

TAPE

FM/AM

AUX/MD

When you press the play button for a particular source (CD 3/8, TAPE 2 3, FM/AM and AUX/MD), the unit turns on (and the unit starts playing the source if it is ready).

� 10 �

English