JVC UX-L40
Manual de Usuario

English

Adjusting the Tone (Bass/Treble)
You can adjust the bass level (low frequency range) and the treble level (high frequency range) within the range of �5 to +5. Normally set these to 0 (initial setting at factory). � This function only affects the playback sound, but does not affect your recording. � There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

Reinforcing the Surround Effect (ONLY FOR UX-L40)
You can reinforce the surround effect. � This function does not affect �your recording. �playback sound of the monaural sources. To get the effect, press SURROUND so that the SURROUND indicator lights up on the display.
SURROUND

SURROUND

1 Press BASS to adjust the bass level or press
TREBLE to adjust the treble level.
BASS TREBLE
BASS TREBLE

SURROUND

To cancel the effect, press SURROUND again so that the SURROUND indicator goes off.

2 Press UP to increase the level or press DOWN
to decrease it.
DOWN UP

Selecting the Illumination Brightness
You can change the illumination brightness only while the unit is turned on.

UP DOWN

On the remote control ONLY:
To change the brightness, press DIMMER. � Each time you press the button, the illumination dims and brightens alternately.
DIMMER

Reinforcing the Bass Sound
You can reinforce the bass sound to maintain rich, full bass at low volume. � This function only affects the playback sound, but does not affect your recording. To get the effect, press AHB (Active Hyper Bass) PRO until �AHB 1� or �AHB 2� appears on the display. The BASS indicator also lights up on the display. � Each time you press the button, the bass sound change as follows:
AHB 1 AHB 2 AHB OFF (Canceled)
BASS

AHB PRO

AHB PRO

�AHB 2� has much more bass reinforcement effect than �AHB 1.� To cancel the effect, press AHB PRO until �AHB OFF� appears on the display and the BASS indicator goes off.

� 11 �