JVC UX-J99DVDAH
Manual de Usuario

In the following examples of track editing, the process is explained from the very first�that is, inserting a disc. You can also edit an MD during playback (in Normal Play).

5 Press SET when you find the point
where you want to divide the track.
�POSIT. (position) 0� appears on the display, and the unit repeats the selected point�a 3-second period following the dividing point.

Dividing a Track�DIVIDE
This function allows you to divide one track into two separate tracks. It is useful, for example, when you want to add track marks at a certain point within a track or if you want to separate a recording. When the original track has a title, two separate tracks are reassigned the same title as the original track in the same group (if the original track is belonged to a group). Once a track is divided, the other tracks are renumbered. � To stop any time during the editing process below before step 8, press TITLE EDIT.

� If the loaded MD has 254 tracks, �DISC FULL� will appear (see �MD limitations� on page 88) and you cannot go to the following steps. � If the dividing point is satisfactory, go to step 7. If not, go to the next step. � To cancel the setting, press CANCEL, then repeat from step 4.

1 Insert an MD you want to edit into the MD
loading slot.
On the remote control ONLY:

6 Press UP ¢ or DOWN 4 to

precisely adjust the dividing point.

2 Press TITLE EDIT repeatedly until
�DIVIDE ?� appears on the display.

When you stop pressing the button, the unit repeats the newly selected dividing point. � You can shift the dividing point up to ±128. This range (±128) corresponds to approximately ±8 seconds* from the original point (position 0).

Ex.: When adjusting the point by �103. � If the loaded MD has no track, �DIVIDE ?� will not appear on the display. � If you want to stop this editing process, press CANCEL.
* When the recording length mode of the selected track is �SP:� For �LP2,� it is approximately ±16 seconds, and for �LP4� approximately ±32 seconds.

3 Press SET.
The first track on the MD starts playback repeatedly.

� When you find the correct position, go to the next step. � To cancel the setting, press CANCEL, then repeat from step 4.

4 Press UP ¢ or DOWN 4 to
select the track you want to divide.
� You can also select the tracks using the number buttons. In this case, the selected track starts playing repeatedly.

7 Press SET.

8 Press ENTER.
Ex.: When track 12 is selected. �EDITING� appears and the REC (MD recording) indicator flashes on the display. Then �WRITING� flashes while editing you have made is being recorded on the MD.

To join the divided tracks, see the JOIN function on page 65.

64

English