JVC UX-B70
Manual de Servicio

3.3.4 Removing the motor board (See Fig.10 , 11) � Prior to performing the following procedure, remove the servo control board. (1) Turn over the body and remove the two screws D. Move the CD module bkt. in the direction of the arrow to release two joints f. (2) Unsolder the four soldered parts on the motor of the motor board. Caution: If removing the motor board with the motor, you should remove the screws attaching the motor from top of the body(Refer to another section). (3) Remove the two screws E attaching the motor board. (4) Remove the spacer fixing the motor board and tray switch board, and disconnect connector CN2 on the motor board. (5) Disconnect the card wire from connector CN1 on the motor board. Caution: When reconnecting the card wire, let the card wire through the slot g of the motor board and attach it to the bottom of the body using a double tape.

f

f

CD Module braket

D

D

Fig.10

Spacer Soldering point CN2

E

E
Motor

CN1

Double face tape

g
Card wire

Fig.11

1-22 (No.MB013)