HITACHI UT32X812
Manual de Servicio

Wiring Diagram page 5 /8
#299 1) Insert the RED tape side of "ECN" in the T-com board. 2) �ECN" must pass on �ELCD3�. *Refer to photo 1 (page3/4) Do the styling so that the wire After dressing �EPS" and �ELCD3�, stick the tape (#299 Nitto tape) on them. Refer to the Final Assy Guide Page 5/9. should not pass the upper part of ELCD3 EPS the shielding case.

D8MW

Do the styling so that the binding tape of �ELCD3� should not pass over the
frame. (Prevent it from touching with the back-cover.)
#299

#SKUL

#SKUL

Insert it surely.

#SKUL ELCD ELCD2

#361

ECN EPS

UT32S402 UT32S602, UT32V502, UT32V502W, UT32X812, ONLY.

12pin

#360 EFF

Detail-1(page2/4) Photo2(page3/4)

ELS NSPK

EISP

NSP EKL EISP EPU #NSP

EISP NEL E001
E002

The wire of �EKL" must go in between the KEY_SW

Photo 4 (page3/4)
IR/POW SW board

Detail-2
(page2/4)

board and the case, the surplus is hold in between. (It is to prevent the electric wire being pinched when tightening up a screw.) *Refer to photo3(page3/4)

Fix with SK binder(#NSPK) so that the wire of �EISP" should not touch the filter board. *Refer to photo5 (page 4/4)

TABLE OF CONTENTS

40