Applying effects
1
Press the capture button or the playback button.
No effect will be applied if neither the capture button or the playback button are turned on (lit). You cannot turn both buttons on simultaneously.
fig.eng-panel1
If you want to apply effects to the sound being recording, turn on the capture button.
fig.eng-panel2
If you want to apply effects to the sound being played back, turn on the playback button.
fig.fx-sw.e
2
Use the Tube simulator button or Effect variation button to select the desired effect.
TUBE SIMULATOR button
Effect Variation switch
3
Use the effect knobs to adjust the character of the effect. If an effect knob is set to the OFF position, that effect will not be applied. Gradually turn the effect knob toward the right to adjust the setting to your taste. * The fat sound produced by the tube simulator will still remain even if the effect knob is turned off.
fig.eng-panel
Effect knobs
* In some cases, applying the effect too strongly may cause the sound to distort. If this occurs, lower the input level. Alternatively, turn the effect knobs toward the left to reduce the depth of the effect.
