|
Usuarios conectados
Actualmente hay 5753 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Troubleshooting
Is the sample rate setting in your software the same as the UA-25�s sample rate select switch setting? Set your software and the UA-25 to the same sample rate. If you change the UA-25�s sample rate, you must disconnect the USB cable that connects the UA-25 to your computer, and then re-connect the USB cable in order for the new setting to take effect. Try adding memory. Adding memory will improve the processing capability of your computer. For details on how to add memory, refer to the owner�s manual of your computer. Is the UA-25 connected to a USB hub? Try connecting the UA-25 directly to the USB connector of your computer itself. Noise may be entering via the line inputs or mic inputs. If a MIDI sound module with a USB connector is connected via USB to the same computer as the UA-25, and the output of the MIDI sound module is connected to the input jacks of the UA-25, noise from the computer may be heard via the MIDI sound module from the UA-25. In this case, you can either connect the MIDI sound module and UA-25 in parallel via a self-powered hub, or connect the MIDI sound module in series or via a MIDI interface. Try making the following changes to the disk drive settings. Some computers may not have the following settings.
1. 2. 3. 4.
In the Windows Control Panel, double-click System. Click the Device Manager tab. Double-click Disk Drives to see the list of devices. From the list, select GENERIC IDE DISK TYPE??, and click Properties to access the GENERIC IDE DISK TYPE?? Properties dialog box.
* In the ?? field of GENERIC IDE DISK TYPE??, there will be a number that differs depending on your computing environment.
5. Click the Settings tab, place a check mark in the check box for the DMA
option, and click [OK] to close the dialog box.
* Depending on your system, a dialog box for DMA settings may appear. Verify the contents of the dialog box, and click [OK] or [Cancel].
6. In System Properties dialog box, click [OK] to close the dialog box. 7. Restart your computer so that the above settings will take effect.
61
|
|
|
> |
|