System settings
Restoring the factory settings (Factory Reset)
This operation will restore the following items set from UA-101 Control Panel to their factory-set state. � Direct monitor mixer (p. 39) � Patch bay (p. 40) � Memory (p. 40)
1 2
fig.system.eps
Disconnect the USB cable from the UA-101. Turn the power switch all the way toward the left to the STANDBY position.
Press
3
Press the digital input switch, STEREO/ MONO select switch, and direct monitor soft control switch to turn them all on ( pressed inward). Set the sample rate switch to 192 kHz.
192kHz
4 5
fig.system-2.eps
Turn the power switch toward the right to turn on the power. The sync indicator will light, then immediately go out.
ON
6
Within three seconds, turn the sample rate select switch to 96 kHz. Then, immediately turn it back to 192 kHz. * You must perform these operations no longer than three seconds apart from each other.
96kHz
fig.system-3.eps
192kHz
7
The input/output level indicators will blink, and the UA-101 will be reset to its factory-set state. Turn the UA-101 off, then on again.
