BANG&OLUFSEN TYPE 2680
Manual de Servicio

5.12

Repair tips, English

Mounting of wire for glass doors
Turn the wire pulley G clockwise until it stops. (Closed door position). Turn the wheel H in click position. Mount the wire in the wire pulley H (the end with the heavy spring). Run the wire in the second innermost groove of the wire pulley H (underneath the pulley), up around the uppermost pulleys (I, J, K and L) and down around the lowermost pulleys (M, N, and O). - Turn the pulley G anticlockwise. - Fasten the wire in the pulley H. - Mount the wire on pulley P and turn pulley G to check that everything is OK. -

Readjustment of wire
- Turn the pulley G such that the centre of the pulleys G and H is �ush with the upper edge of the tower X. - Push the wire clamping clip towards the centre and tighten (not too tight).
L I J K

X H G

M

P

O

N