BANG&OLUFSEN TYPE 2576
Manual de Servicio

1.8

Brief operation guide

The PIN-code system

Activate the PIN-code system
While the BeoSound 9000 is in stand-by mode you can set up the PIN-code.

Change or delete your PIN-code
While the PIN-code function is turned on you can always make changes to the PIN-code.

Using your PIN-code
When a PIN-code has been programmed, and the BeoSound 9000 has been disconnected from the mains for more than 30 minutes, you must enter the PIN-code when the BeoSound 9000 is turned back on.

p p PAUSE
NEW PIN

Press p twice followed by PAUSE to activate the PIN-code function. The display shows NEW PIN for 1.5 sec.� �then you can enter a PIN-code Press to select a digit*

p p PAUSE
PIN _ _ _ _ NEW PIN?

Press p twice followed by PAUSE to activate the PIN-code function Enter the current PINcode. The display shows NEW PIN?

PIN _ _ _ _

Enter the PIN-code Press to select a digit

m p OK
R ADIO 1

Press to accept the digit When the PIN-code has been entered the display returns to the relevant source display e.g. RADIO 1

PIN _ _ _ _

m p OK

m p
NEW PIN? PIN OFF?

Press to choose from the two options NEW PIN? or PIN OFF?

Press to accept the digit Select NEW PIN? to change your PIN-code If an incorrect PIN-code is entered the display will show ERROR and you may try again. After the �fth try, the BeoSound 9000 is turned off, and must be left in stand-by mode for 3 hours, before you can try again.
PIN _ _ _ _

The digit is replaced by a * and the next underscore blinks. Continue to enter the last three digits in the same manner. If you wish to change the entered digits� RESET Press to start entering from the beginning

Enter the new PIN-code Press to accept the new PIN-code. The display shows CONFIRM for 1.5 sec.� �then re-enter the new PIN-code

OK
CONFIRM

PIN _ _ _ _

When the PIN-code has been entered� OK Press to accept the PINcode. The display shows CONFIRM CONFIRM for 1.5 sec.�
PIN _ _ _ _

Did you forget your PIN-code?
Should you forget your PIN-code you can require a �ve-digit Master Code from your Bang & Olufsen retailer.

OK

Press to con�rm the new PIN-code The display shows that your new PIN-code is stored

�then re-enter the PINcode Press to con�rm the PINcode The display shows that your setting is stored

STORED

OK

STORED

Select PIN OFF? to delete your PIN-code When you have received a Master Code� DELETED The PIN-code function is PIN _ _ _ _ When the display is disabled and the display open for PIN-code shows DELETED for 3 sec. input� For security reasons it is only possible to change or verify the PIN-code �ve times within a period of 3 hours. If an incorrect code is entered �ve times, BeoSound 9000 is turned off, and must be left in stand-by mode for 3 hours, before you may try again. p
PIN _ _ _ _ _

If an incorrect code is entered the second time you must set up the PIN-code from the beginning.

Press the p button for more than 3 seconds to change the display to �t 5 digits

PIN _ _ _ _ _

Enter the Master Code Press to select a digit

m p OK
DELETED

Press to accept the digit The display shows that the PIN-code lock is off

*NOTE!: It is also possible to enter the digits using the number keys 0 � 9 on your Beo4 remote control.

When the Master Code is entered, the BeoSound 9000 can be used without entering the code again.