ONKYO TX-SR804
Guía de consulta rápida

Turning on & Using Automatic Speaker Setup
With the supplied speaker setup microphone, use the Automatic Speaker Setup function. Before using this function, connect and position all your speakers.

1
AV receiver
STANDBY/ON

Remote controller
RECEIVER

Press the [STANDBY/ON] button on the AV receiver or press the remote controller�s [RECEIVER] button followed by the [ON] button to turn on the AV receiver. Turn on the TV and select the input to which the AV receiver is connected.

or
ON

2

SETUP MIC

MIC position

Put the speaker setup microphone in the listening position, and connect it to the SETUP MIC jack on the front panel. And press [ENTER]. The automatic speaker setup starts. The whole process takes about 2 minutes.

ENTER

Auto Speaker Setup -----------------------Push Enter:Start Caution! Loud sound.

3
Auto Speaker Setup -----------------------Apply the Results
ENTER
ENTER

When you�ve �nished the setup, press the Up and Down [ ]/[ ] buttons to select �Apply the Results,� and then press [ENTER]. Disconnect the speaker setup microphone.

Check the Results Retry Retry with Test noise Level up Cancel

Selecting the Input Source

1.

Use the AV receiver�s input selector buttons to select the input source. To select the input source with the remote controller, press the [RECEIVER] button, and then use the INPUT SELECTOR buttons. Start playback. To adjust the volume, use the MASTER VOLUME control, or the remote controller�s [VOL] button.

3
MASTER VOLUME STANDBY/ON STANDBY ZONE 2

PURE AUDIO

MULTI CH

DVD

VIDEO 1

VIDEO 2

VIDEO 3

VIDEO 4

TAPE

TUNER

CD

PHONO

DISPLAY

2. 3.

PUSH TO OPEN

1
I0609-1

SN 29344330
(C) Copyright 2006 ONKYO CORPORATION Japan. All rights reserved.

*29344330*