NUMARK TT1700
Manual de Usuario

TT1700

OPERATING INSTRUCTIONS

PLACEMENT

�Do not place the unit in a location where it will be exposed 1. Push the power button to turn on the power, the speed to direct sun light or near a heating appliance. indicator and the strobe-illuminator will light up. �Do not place the unit in a location where there is high humidity or a lot of dust. 2. Place a record on the turntable mat, when playing a 45rpm �Cartridge may pick up slight sound pressure or vibrations of record with a large center hole, place the 45-rpm adaptor the speakers coming along the floor or through the air on the center spindle. resulting in howling. Find a location which is very stable 3. Set the rotation speed (33/45) to match the record. and free vibration. �The legs have functions for adjusting the height of the unit 4. Remove the stylus protector, release the arm clamp. itself. Adjust the legs to stabilize the main body 5. Set the cueing lever to the up position. horizontally.

6. Press the Start/Stop button, the turntable platter will start to MAINTENANCE rotate. �Clean the stylus periodically with a soft brush to prevent the 7. Move the tonearm over the desired groove. 8. Set the cueing lever to the down position, the tonearm will descend slowly onto the record and play begins. 9. To suspend play, lift tone arm with cueing lever. 10. When play is finished,raise the cueing lever, move the tonearm to the arm rest, secure the tonearm with the arm clamp . 11. Press the Start/Stop button to stop the platter rotating, push the power button to turn off the power. accumulation of dust. �When the sound becomes distorted or noisy, check the stylus. If worn out, replace it with a new one. �From time to time, the dust cover and turntable cabinet should be wiped with a soft, dry cloth. Any volatile materials as alcohol,thinner, benzine, etc.,may remove the paint or damage the luster, should not be used.

SPECIFICATIONS

Turntable section Type 2-speed, full manual Driving method Belt drive TARGET LIGHT Motor DC motor This unit is provided with a target light for illuminating the Turntable platter Aluminum diecast 330mm dia. stylus tip during play. Push the target light button, the Turntable speed 33-l/3 and 45 rpm target light will be raised into position for illuminating the Starting torque more than 650g-cm stylus tip. When not in use, keep the target light lowered Wow and flutter Less than 0.25% through depression. S/N ratio 50dB (DIN-B) Tonearm section PITCH ADJUSTMENT Type Universal s-shaped tubular arm The pitch control is variable in a range of +/- 10%. During play, Effective length 220mm observe the strobe dots, if the strobe dots appear to the General right, the pitch is slower than the rated speed, if flow to the Power supply AC110-127V/220-240V,50/60Hz left, the pitch is faster than the rated speed, if the strobe Power consumption 8 Watts dots appear stationary, which means the platter is in Dimension(WxDxH) 450 x 350 x 148 mm normal turntable speed. Move the pitch control slider up or 17 3/4� x 13 3/4� x 5 7/8� down to adjust the speed. Weight 6.5 Kgs 14 lbs Specifications and design may be changed without notice for improvement.

Numark - The Proven Leader in DJ Technology ©1997 Numark Industries 7 http://www.numark.com