DRAINAGE SYSTEM
Direct drainage at the rear of the dryer
To avoid to empty the water container at the end of each drying cycle, connect the pipe supplied in the dryer directly to a fixed drain or put it into a sink. 1. Remove the pipe in the lower part behind the dryer and mount it to the plastic connector (shown in driagram), put a rag underneath to collect water spillage. 2. Connect the pipe supplied with the dryer to the connector. The maximum drain height is 1m. 3. Make sure that the pipe is not bent or twisted (the end of the pipe must not be immersed in the drain water to avoid risk of siphoning). The supplied hose length is 1,5m. The maximum permitted length is 2,5m.
DOOR REVERSIBILITY
To change the direction of opening of the clear door 1. Unplug the dryer. 2. Open the door. 3. Remove the contact pin at the upper part of the door with a spanner. Turn the contact pin 90° and take it out. 4. Unscrew the 2 screws at the door hinge and remove the door. 5. Unscrew the 2 screws above and below the door lock system and remove the plate. 6. To remove the door lock: � Press the hook at the upper part down with a screwdriver, pull it forward and take the lock system out. 7. To change the door opening: � Turn the door. � Re-fit the door with the 2 screws at the preferred position. � Hang the door lock system at the opposite side of the door and latch it. � Fix the plate with the 2 screws above and below the door lock system. � Take care not to reverse the sense of the plate. The door lock should be free to move. 8. Replace the contact pin in the top of the door.
