|
No hay comentarios de productos.
POWER-ON MESSAGE
Each time you switch the transceiver ON, the factory-default message appears and stays for approximately 2 seconds. You can program your favorite message in place of �KENWOOD�. 1 Press [MNU] to enter Menu mode. 2 Select Menu No. 2 (Front Panel).
CALL PWR
�
To skip by four characters when operating the above control or keys, press [MHz]. Press [MHz] again to quit this jump function.
1 2 3 4 5 6 7 8 9 10 11
7 Press [s]. s
� The second digit blinks.
8 Repeat steps 6 and 7 to enter up to 7 digits.
� � � After entering the 7th digit, pressing [s] causes an error s beep to sound. To re-enter the preceding digit, press [t]. t To clear all digits and move back to the first digit, press [VFO].
VOL
SQL
9 Press [SET] again to complete the setting. 10 Press [MNU] to exit Menu mode. 3 Press [s], then select Item No. 2 (Power On Msg). s
CALL PWR
DISPLAY DEMONSTRATION MODE
By initiating this mode, various pre-programmed displays appear. You still can normally use the transceiver in this mode. Pressing buttons or microphone keys, or turning the Tuning control restores the operating display immediately. If there is no button/key entry or Tuning control adjustment for approximately 12 seconds, the transceiver reverts back to Demonstration mode. Press [F]+ POWER ON to toggle the mode ON or OFF.
12 13 14 15 16 17 18 19 20 21
VOL
SQL
2
1
4 Press [SET].
� The last digit blinks.
5 Press [VFO].
� The cursor moves to the first digit.
6 Turn the Tuning control, or press Mic [UP]/[DWN], to select the first digit.
69
|
