|
|
|
Usuarios conectados
Actualmente hay 5808 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
TM-271A/271E
RESETTING THE TRANSCEIVER
Resetting the Tansceiver
If your transceiver seems to be malfunctioning, resetting the microprocessor may solve the problem. The following 2 reset modes are available. When performing the reset, you may lose memory data and stored information. Back up or write down important data before performing the reset.
â� VFO Reset
This resets the transceiver parameters excluding the DTMF Memory, the Memory channel contents, and the Call channel contents. There are two methods available for resetting the transceiver. Note : Menu No. 7 (P.VFO) and Menu No. 10 (OFFSET) return to the factory default values.
â� Initial Settings
The factory defaults for the operating frequencies are as follows. Transceiver : 144.000MHz The Memory Channels have no data stored. The Weather Radio frequency (AL channel) is restored as 162.550MHz (K market model only). The Call Channel and frequency step size default values. Note : When in Channel Display Mode or while Key Lock is activated, you cannot perform VFO reset or Full reset.
� VFO Reset Method 1:
1. With the transceiver power OFF, press [VFO]+[ ] (Power). � The VFO reset confirmation message appears.
â� Full Reset
This resets all transceiver parameters to the factory default values. There are two methods available for resetting the transceiver.
2. Press [VFO]. � �SURE ?� appears. � Press any key other than [VFO] to cancel. 3. Press [VFO] again to reset the transceiver. � �WAIT� appears momentarily.
� Full Reset Method 1:
1. With the transceiver power OFF, press [F]+[ ] (Power). � All indicators light momentarily, followed by the full reset confirmation message.
� VFO Reset Method 2:
1. Press [F], [MENU] and turn the Tuning control to select Menu No. 99 (RESET). 2. Press [MENU] and turn the Tuning control to select �VFO�. 3. Press [MENU]. � �SURE ?� appears.
2. Press [F]. � �SURE ?� appears. � Press any key other than [F] to cancel. 3. Press [F] again to reset the transceiver. � �WAIT� appears momentarily.
� Press any key other than [MENU] to cancel. 4. Press [MENU] to reset the transceiver.
� Full Reset Method 2:
1. Press [F], [MENU] and turn the Tuning control to select Menu No. 99 (RESET). 2. Press [MENU] and turn the Tuning control to select �FULL�. 3. Press [MENU]. � �SURE ?� appears.
� Press any key other than [MENU] to cancel. 4. Press [MENU] to reset the transceiver. � �WAIT� appears momentarily.
19
|
|
|
> |
|
