|
|
|
Usuarios conectados
Actualmente hay 6043 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
Chapter 7
Projector Setup
Plug in the power cord; turn on main power switch and the power of the projector.
How to enter to the Factory Mode (TLP-X2500/XC2500/X3000/XC3000)
1) While the Volume adjustment bar is displayed on the screen, set value to [2], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously. 2) While the Volume adjustment bar is displayed on the screen, set value to [0], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously. 3) While the Volume adjustment bar is displayed on the screen, set value to [0], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously. 4) While the Volume adjustment bar is displayed on the screen, set value to [0], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously.
When the projector enters to the Service Mode, the buzzer beeps for 3 seconds. If doesn�t beep, repeat from the beginning. This mode maintains until you turn off the main power switch.
7-3
|
|
|
> |
|
