TKR-751
INSTALLATION
Note :
Relationship between TEST/SPKR connector (15-pin) connection and speaker output. When pins 9 and 12 are shorted : Built-in internal speaker is used. When pins 9 and 12 are open and output is from pins 6 and 12 : KES-4 or KES-5 is used.
4. Accessory Cabinet
You can install optional accessories, such as a DC power supply or duplexers in the accessory cabinet. 1. Place the optional accessory in the cabinet as shown below. 2. If necessary, attach cushions (G13-1801-04 and/or G131802-04) to the top plate (J21-8402-04) in order to adjust the space between the cabinet and the top plate. Then, insert the 3 tabs of the plate into the slots in the side of the cabinet. High, middle, or low positions are available. To afix the plate, inset and tighten 2 screws on the other side of the plate. You can also flip the top plate upside-down to adjust a height of the cabinet space.
Tighten screws Cushion (G13-1801-04 or G13-1802-04) Hardware fixture Insert the plate tabs to set the height position (high, middle, or low).
Fig. 4-1
or
Fig. 4-2
The top plate can be inverted to adjust the height of the cabinet space.
