TK-2180
DISASSEMBLY FOR REPAIR
2. How to Stick the Sheet (G11-4326-04)
1) Remove the white separation paper of the sheet first (q) and stick the sheet on the front-glass (w). Next, remove the transparent separation paper of the sheet (e).
Sheet (G11-4326-04) e
4. How to Attach the VGS-1
1) Remove the 2 screws. 2) The tip of tweezers is put into the screw hole of the cover and is pried, the cover will remove. 3) Use the 2 rubber cushions and attach them to the VGS-1. 4) Plug the VGS-1 into the VGS-1 connector of the PC board, pressing down on the top of the VGS-1 until secure. 5) The spacer turns the adhesive surface down. Next, push between the chassis and VGS-1. 6) Replace the cover and tighten the 2 screws.
q
Front-glass w
3. How to Attach the TX-RX Unit
1) In order to attach the TX-RX unit in chassis, don�t put in the TX-RX unit aslant. Please level the chassis and the TX-RX unit and attach them.
Rubber cushion (G13-1995-04) 20 x 30 x 1.0 mm
VGS-1
Rubber cushion (G13-1974-04) 21 x 21 x 2.5 mm
VGS-1 VGS-1 connector Spacer (J30-1292-04) 4.5 x 24 x 3.0 mm
