TH-A10R/TH-A10
Removing the eject board (See Fig.28)
1. Disconnect the harness from connector CN702 on the eject board. 2. Remove the three screws P board. attaching the eject
Eject board Switch board
P
Removing the LCD board (See Fig.29)
1. Remove the four screws Q attaching the LCD board. 2. Unsolder WA701, WA703 and WA704 on the LCD board.
CN702
T
Fig.28
Q
Removing the IC board (See Fig.27)
1. Remove the screw R attaching the IC board. 2. Disconnect the harness from connector CN706 on the IC board.
WA701 LCD board
Q
WA704 WA703
Q
Removing the LED board (See Fig.27)
Prior to performing the following procedure, remove the LCD board and the IC board. 1. Disconnect the harness from connector CN705 on the power switch board. 2. Remove the two screws S attaching the LED board. Fig.29
Q
IC board
R
CN706 Power switch board
O O
Removing the switch board (See Fig.28)
Prior to performing the following procedure, remove the LCD board.
S
1. Disconnect the harness from connector CN702 on the eject board. 2. Remove the two screws T board. attaching the switch Fig.27