PANASONIC TH65PF10UK
Manual de Usuario

Adjusting POS. /SIZE
AUTO SETUP Automatically adjust H-POS / V-POS / CLOCK PHASE / DOT CLOCK and set H-SIZE / V-SIZE the standard value when RGB signal is input. Notes: � If the dot clock frequency is 162 MHz or higher, DOT CLOCK cannot be made. � If the image is that the edge is hardly �gured out or shadowy, that cannot be adjusted automatically. In such case, press AUTO SETUP again after changing the image to the clearer one. � When DVI-D is input, CLOCK PHASE cannot be adjusted automatically. � Select NORMALIZE in POS. /SIZE and press the ACTION ( ) button when appropriate adjustment cannot be made. Adjust the horizontal position.

H-POS

H-SIZE

Adjust the horizontal size.

V-POS

Adjust the vertical position.

V-SIZE

Adjust the vertical size.

DOT CLOCK

(During �COMPONENT�, �RGB� and �PC� input signal) Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens, adjust so that any such noise is minimized. (During �COMPONENT�, �RGB� and �PC� input signal) Eliminate the �ickering and distortion.

CLOCK PHASE

1:1 PIXEL MODE Adjusts the display size when 1125i, 1125p or 1250i signal is input. Notes: � Select ON when you would like to replay 1920 � 1080 input signal. � Applicable input signal; 1125 / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p, 1250 / 50i � Select OFF when �ickering is shown around the image. � H-SIZE, V-SIZE and DOT CLOCK cannot be adjusted when ON is selected.

OFF

ON

Helpful Hint (

/

NORMALIZE

Normalization)

While the POS. /SIZE display is active, if either the N button on the remote control is pressed at any time or the ACTION ( ) button is pressed during �NORMALIZE�, then all adjustment values are returned to the factory settings.

23