11 Trouble shooting guide
11.1. Self Check
1. Self-check is used to automatically check the bus line controlled circuit of the Plasma display. 2. To get into the Self-check mode, press the volume down button on the customer controls at the front of the set, at the same time pressing the OFF-TIMER button on the remote control, and the screen will show :If the CCU ports have been checked and found to be incorrect Or not located then " - - " will appear in place of " OK "
11.2. No Power
11.2.1. Power LED Blinking timing chart
1. Subject Information of LED Flashing timing chart. 2. Contents When an abnormality has occurred the unit, the protection circuit operates and reset to the stand by mode. At this time, the defective block can be identified by the number of blinkes of the Power LED on the front panel of the unit.
3. Remarks Above Fan function is operated during the fans are installed. 26