This section describes how to:
�clean the lens �replace the projection lamp �replace the batteries in the remote �use the security lock feature �troubleshoot the projector
Cleaning the Lens Follow these steps to clean the projection lens: 1 Apply a non-abrasive camera lens cleaner to a soft, dry cloth.
� Avoid using an excessive amount of cleaner, and don�t
apply the cleaner directly to the lens.
� Abrasive cleaners, solvents or other harsh chemicals might
scratch the lens. 2 Lightly wipe the cleaning cloth over the lens in a circular motion. 3 If you don�t intend to use the projector immediately, replace the lens cap. Replacing the Projection Lamp The lamp hour counter in the Status menu counts the number of hours the lamp has been in use. Change the lamp when the brightness is no longer acceptable. You can order new lamp modules from your Toshiba dealer. See �Accessories� on page 36 for information. Follow these steps to replace the projection lamp: 1 Turn off the projector and unplug the power cord. 2 Wait 30 minutes to allow the projector to cool thoroughly.
WARNING: To avoid burns, allow the projector to cool for at least 30 minutes before you open the lamp access grill. Never extract the lamp module while the projector is operating.
