TOSHIBA TDP-MT400
Manual de Usuario

English

Français

Español

Deutsch

Italiano

Português Svenska

Basic operations (Continued)

Using handy features
� Using auto setting
This function sets up the projector to the optimum state for each type of the input signal by using simple operations.
Control panel Remote Control

5 Projector placement angle adjustments
The placement angle and the height of the projected image can be adjusted by the foot adjuster.

q Lift up the front of the projector to the desired angle, then press the foot adjuster release button.
The foot adjuster extends. Release the button to lock the position.

1 Press the SET UP button.
1

The Set up menu appears.

2 Press the SET UP button again.
The displayed menu item is automatically adjusted/set. For computer input, the icon will appear during processing. For manual adjustment and setting, see the following table p.26 .

w To adjust the horizontal angle, use the tilt adjuster.
To stow the foot adjuster, hold up the projector while pressing the foot adjuster release button, then slowly lower the projector.
2

Notes
� The image may not be projected or auto adjustment/setting may not be performed correctly for input signals other than those supported by the projector p.39 , p.40 , p.41 . � Keystone adjustment cannot be corrected automatically.
1

6 Adjusting the screen size and focus
q Use the zooming lever to adjust the screen size. w Use the focusing lever to adjust the focus.
Readjusting the projection size with the zooming lever after focusing will cause the projected image to be out of focus. In that case, perform focusing again.

� Correcting the keystone distortion

Notes
� Note that lamp characteristics may rarely cause the brightness to fluctuate slightly. � A lamp is consumable item. If used for extended periods, images will appear dark, and the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime of the lamp depends on conditions of use.) � The DMDTM is made using extremely advanced technology, but there may be black spots (pixels that do not light) or bright spots (pixels that are constantly lit) on the panel. Please note that these are not malfunctions. Although this projector supports a wide range of RGB signals p.39 , any resolutions will be expanded or shrunk, which will affect image quality slightly. With some models of computer having LCD displays or the like, displaying images simultaneously on the projector and the monitor�s display may prevent the images from displaying properly. If this happens, turn off the computer�s LCD display. For information on how to turn off the LCD display, see the owner�s manual of your computer. If a signal not supported by the projector is input, the �Unsupported signal� will appear. If no signal is being input from the connected device, the �No signal� will appear. If an unavailable operation button is pressed, the icon will appear.

Before correction After correction

� Manual adjustment
Press the SET UP button to display the Set up menu and select [Keystone]. Use the buttons for keystone adjustment. When the adjustment is finished, press the RETURN button. The menu disappears.

� �

Notes
� Depending on the amount of keystone adjustment and the content of images, some information may be lost, or the picture quality may suffer. � Keystone adjustment is available for the keystone distortion in a slant angle of ±15 degrees. � Keystone adjustment will not change the shape of the menus, the start-up screen, and the background (with no signal input).

� � �

24

25

Operations

2

When the foot adjuster p.24 is used to change the projector placement angle while projecting the image, the picture will undergo keystone (trapezoidal) distortion. This projector is capable of correcting this keystone distortion.