|
|
|
Usuarios conectados
Actualmente hay 5898 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
SECTION 1 SERVICE NOTE
ALL CLEAR Mode which erases all the user memories registered in this unit and sets to setting at shipment. Method: 1. With the power turned OFF, press the POWER button while pressing the TAPE MONITOR button and VIDEO 2 button simultaneously to turn ON the power. 2. ALL CLEAR ! will be displayed on the fluorescent indicator tube, and ALL CLEAR will be executed. FACTORY SET Mode which sets the memory of the unit to the setting of adjustment and check at factory. (Not used for servicing.) Method: 1. With the power turned OFF, press the POWER button while pressing the SPEAKER button and TAPE button simultaneously to turn ON the power. 2. FACTORY SET will be displayed on the fluorescent indicator tube, and FACTORY SET will be executed. Note: In case you return the unit to the customer, do not perform FACTRY SET. If you do it, perform ALL CLEAR. Fluorescent indicator tube, LED all lit mode and key check mode Method: 1. With the power turned OFF, press the POWER button while pressing the TAPE MONITOR button, VIDEO 1 button, and VIDEO 2 button simultaneously to turn ON the power. 2. The fluorescent display tubes and LEDs will all light up. 3. The display will change as follows each time buttons other than GENRE and MODE are pressed. Therefore, it can be checked if buttons have been input properly by whether the display changes. N Adjustment of OSD Screen Position The position of the screen can be adjusted freely to correct the deviation of the OSD screen caused by the monitor type that users are using. 1. Move the cursor of the remote commander attached, and display the OSD screen. 2. Click the MAIN MENU FUNCTION of the OSD screen. 3. Next click TV SET. 4. Next click GRAPHIC POSITION SET. 5. The screen for adjusting the OSD screen position will be displayed. Adjust the position with the remote commander attached. 6. Click EXIT to end.
Fluorescent indicator tubes, LEDs are all lit N Press any button
Partial lighting of fluorescent indicator tube 1, LEDs are OFF *1 N Press any button
Partial lighting of fluorescent indicator tube 2, LEDs are OFF *1 N Press any button
Fluorescent indicator tube and all LEDs are OFF *1 N Press any button
*1 Those other than the POWER LED go OFF. 4. To exit the mode, press the POWER button to turn OFF the power.
�3�
|
|
|
> |
|
