being held by glue. When the flat pack-IC is removed from the CBA, handle it gently because it may be damaged if force is applied.
2. Installation
1. Using desoldering braid, remove the solder from the foil of each pin of the flat pack-IC on the CBA so you can install a replacement flat pack-IC more easily. 2. The ��� mark on the flat pack-IC indicates pin 1. (See Fig. S-1-7.) Be sure this mark matches the 1 on the PCB when positioning for installation. Then presolder the four corners of the flat pack-IC. (See Fig. S-1-8.) 3. Solder all pins of the flat pack-IC. Be sure that none of the pins have solder bridges.
Hot Air Blower
or Iron Wire
Soldering Iron To Solid Mounting Point Fig. S-1-5
Example :
CBA
Fine Tip Soldering Iron
Pin 1 of the Flat Pack-IC is indicated by a " " mark. Fig. S-1-7
