What to do if ...
If the tumble dryer is not working correctly please carry out the following checks before calling out an engineer.
Symptom Possible cause The appliance is not plugged in The fuse has blown The START/PAUSEbutton has not been pressed The tumble dryer will not start No programme has been selected The door is not properly closed The water reservoir is full The wrong programme has been selected Fluff filter blocked heat exchanger unit covered with fluff The tumble dryer has been overloaded The results are unsatisfactory Laundry not sufficiently spun prior to tumble drying The vent in the base of the appliance is covered A residue may have formed on the drum interior, blocking the sensors Select the required programme Close the door Empty the water reservoir Select a different programme Clean the fluff filter Clean the heat exchanger unit Observe the maximum loads stated for each programme Ensure the wash load is well spun before tumble drying Ensure the vent is clear Solution Plug in the appliance Check the fuse Press the START/PAUSE button
