INSTALLATION INSTRUCTIONS
Exhaust venting
The moist air from the dryer must be vented to the outside. The appliance should not be vented into a chimney, a wall, a ceiling, or any concealed spaces of the building. When installing, try to avoid: - very long venting systems - too many bends or angles - tight corners otherwise . . . . . . the drying results will be affected, . . . drying will take longer and use more energy. Materials suitable for venting: � rigid metal pipe � flexible metal pipe To prevent the risk of fire, do not use vinyl or foil ducting for venting. Install the venting in such a way that the expelled air cannot be drawn back into the machine. Do not vent the dryer into a flue used by gas or fuel boilers or heaters. A vent connector is included with the machine. It should be pressed into the vent outlet and will simplify the connection of the exhaust pipe. Before installation, disconnect the tumble dryer from the electrical supply (unplug from the wall socket, or turn off the circuit breaker. Installation at the rear The machine comes supplied with the connector installed on the rear exhaust port. Installing the connector on the left side of the machine Remove the cap covering the exhaust part as follows:
� Insert a thin screwdriver into the slot by the retaining hook. Press the hook gently upwards. At the same time turn the cap counterclockwise.
In the same way remove the vent socket from the rear exhaust port. Secure into the side port by pressing it in and turning it clockwise. Seal the rear exhaust port using the cap.
