SWR SUPER REDHEAD
Manual de Usuario

The Headphone jack allows the user to monitor the sound via the use of stereo headphones. To practice without sound coming through the Super Redhead�s speakers, turn the Speaker On/Off switch to the �Off� position and connect headphones to the Headphone jack. Stereo headphones must be used in this jack, as mono headphones will short out one side. Since the headphone �amp� is actually a reduced signal from the power amp, the Headphone volume is controlled by the Master Volume control. SPEAKER ON/OFF SWITCH Setting the Speaker On/Off switch to the �On� position allows the speakers to function as normal. Turning the switch to the �Off� position cuts the signal off to the Super Redhead�s internal speakers. This feature does not affect the external speaker output jack. The Speaker On/Off switch allows the user to: 1. Use the record out system without using the internal speakers. This is especially useful when only a direct signal is required. 2. Practice in a quiet environment without disturbing your neighbors by using the Headphone jack. 3. Tune up without interfering with other band members when using the Tuner Input jack. POWER ON/OFF SWITCH Setting the switch to the �On� position activates the electronics in the Super Redhead as indicated by the Power LED lighting.

REAR PANEL FEATURES
EFFECTS LOOP The Effects Loop accepts any line level effects unit. Many high quality effects on the market have input level adjustments, usually a switch that can be set for either �10dB or +4dB. In all cases, these should be set for either 0dB or +4dB. The level going to your effect is controlled by the Gain control. The Effects Loop is designed as a �side chain� and functions similarly to recording studio mixing consoles. Because the Effects Loop is after the preamp gain stages in the signal chain, use of the Effect Loop should greatly reduce any residual noise generated by your effects unit (as compared to using an effect �in line� between your instrument and the input to the Super Redhead). SEND To use an effect in the Effects Loop of your Super Redhead, connect a shielded patch cable from the Send jack to the input of your effects unit. The output impedance of the Send jack is 100 ohms. This jack may also be used as a line level output for use in conjunction with an external �slave� power amp. RECEIVE After connecting the send jack as described above, connect a shielded patch cable from the Receive jack to the output jack of your effects unit. The input impedance of the Receive jack is 27kohms minimum. A unique feature of the Receive jack is that you can practice along with pre-recorded music. To do this, insert a tape recorder or other sound source into the Receive jack (make sure it is a mono source). Using the Effects Blend control on the Super Redhead�s front panel, adjust the level of the outside source so that a good blend is achieved with the sound level of your instrument. The blended signal can be heard through the internal speakers or through the Headphone jack. This same procedure can be used for playing along with a drum machine, sequencer, etc.
SUPER REDHEAD OWNER�S MANUAL � 7